Older versions of the PMK can be easily acquired through sites such as eBay and military surplus stores. The rubber parts of the mask are always black. Later versions have the metal components of the mask left unpainted. This system is compatible with standard type m drinking systems.Įarly versions of the PMK have the trim around the lenses and over the voice diaphragm painted black. The system consists of a special canteen cap, which will only allow water to flow through when connected to the tube leading to the mask. The PMK gas mask contains a drinking tube, allowing soldiers wearing the mask to rehydrate without removing the mask itself. Although the filters are similar to and have the same 40 mm GOST threads as the GP-5 gas mask, they are a slightly different design, having a sloping top with ridges stamped into the metal. The filters themselves are designed to filter out toxic or radioactive vapors or aerosols, as well as biological agents. However, the filter could be mounted on both sides on the PMK-2 and later models. The original PMK mounted the filter on only the left side of the mask. When you breathed out the whole mask was pushed away from your face to let the air out. When you breathed in the air was sucked through the filter to take out the gas. It was difficult to breathe when wearing a gas mask. It can be distinguished from its civilian counterpart, the GP-7, by its rounded triangular lenses, versus the GP-7's circular lenses. The masks were made of black rubber, which was very hot and smelly. The PMK gas mask represents a family of gas masks used by the Soviet Armed Forces, and later by the Armed Forces of the Russian Federation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |